Indoor tronGrows

Hiya! Good to see you're back at it!

I'm going to re-read this thread because my current grow consists of one plant that just happens to look a lot like some of the plants that you've grown. She's a Chemdog photo that sprouted on 1/1/23. She was topped and LST'd, and was vegged for 64 days under a Growcraft X2 veg light. When I flipped her 14 days ago, she was 12" tall, AKA "a shrubbery".

IMG_9912.jpeg


Interesting comment about switching nutes. I switched from Botanicare Kind to a dry fert a few grows ago and haven't looked back.

[time passes - rad parts of the thread ]

Found it!

I've been trying to remember where I read about removing branches in the undercarriage that are "thinner than a pencil". I read four cannabis sites (three daily) and, lo and behold!, it was @Death The Cultivator earlier in the thread. That's an excellent tip!
 
I've been dealing with GTA for years & have always had good results probably just the seed pak.:bump:

Yeah like I said, I’m a big fan as well and have had great success germinating other seeds from there. Their prices and customer service is top notch. Something about this pack just didn’t like what I was doing. Oh well!

I should also add that I don’t normally do a peroxide soak before popping seeds, but after the few instances of damping off, I decided to give it a try. And whataya know, that seemed to make it work. :D
 
Last edited:
Topped and getting ready to go into a 7 gallon fabric pot. I have it assimilating in the tent and will probably transplant in the next 3 days or so.

I gave it one "plainer" watering with 80ppm cal-mag, 3mL Diamond Nectar (Humic Acid), pinch of Silica and Yucca Powder with 0ppm starting water. I think I did too much 0ppm watering in between fertigations during tronGrows #6, and noticed some what looked to be micro-nutrient deficiencies. This time around, I'm probably foregoing 0ppm watering altogether and at the very least adding ~50-80ppm of cal-mag during my "plainer" waterings, if for nothing other than better pH'ing.

Growth is starting to pick up its pace, which is nice :bighug:

Lights around 400PPFD at 18/6. Temp is 25C; RH is 57-62%.

IMG_2613.jpg


Thanks for stopping by.

tron
 
Topped and tied...

IMG-2695.jpg


IMG-2696.jpg


IMG-2697.jpg


Lights around 450-500 PPFD; last feed was 500ppm; Temps 25C; RH around 55%.

This thing is has some pretty tight node spacing which might be a bit of a challenge with the SCROG but we'll see. Like I said, I'm in no rush with this one - however long it takes to fill the screen... Speaking of which, I need to get that built....

tron
 
Back
Top