BlueCheese day#49, it's 6ft.
IMG_20181019_085247_242.jpg
IMG_20181019_085247_247.jpg
 
okay maybe I not press hard enough I was afraid to break also, tomorrow when I clean up this mess once again I will make sure one way or the other this never happens again, this the last flood you'll ever here me mention! Now I'm be much more proactive about this...
Try just a dab of cooking oil on the t before you push the float down on it, worked for me.
 
Day 52 of the airport test!

It honestly took a little getting used to coming from hand watering. Some good trial and error. I've decided that I like to fill the res 2-3 gallons at time in veg, and 3-4 gallons at a time in flower. Its hard to make feed adjustmets with 10 gals of sitting water.

The SODK is a big ole beast and about to start frosting and flowering. The Green Poison is a short, thick lady. She's a finicky feeder.its been tough to dial her in. Shes on full flower mode now. All else is well!

Tent shot: 110w total!
View attachment 962592

Sodk
View attachment 962593 View attachment 962594

Green Poison
View attachment 962595 View attachment 962597
Very nice garden!!!
 
I'm glad you got it solved! Now looking forward to seeing your girls strut their stuff
Haha me too, It hasn't affected any of them which is good, well one I think it might of so I gave correction flush because the strong nutes filled every tray in the tent and the smallest plant should never of gotten something like that it wasn't ready, hopefully I took care of it before it shows she was over-dosed for maybe 16hrs or so another 48hrs I'll know... :pop::smokeout:
 
Autopot question. Is it ok to rotate the pots in the tray? I usually do my cloth pots to help the coverage of the outside growth as well as the inner.
I move the trays and everyday I visit them I turn the pot in the tray a quarter turn. By all means move 'em where you think is best. Just beware of the tubing.
 
Try just a dab of cooking oil on the t before you push the float down on it, worked for me.
Good tip. Another is to flip the sheet of plastic that covers the valve. Have the side with the little posts stick up. It makes it easier to remove that plastic piece when you need to get at the valve. Whenever I start a tray on the rez. I always check to see if the water is filling the tray.
 
Back
Top