Grow Mediums AFN Communal Autopot Test Summer 2018

[Archaic]

I'll go look again, but mine felt like I'd break it if I tried to force it down.

 

[Dudeski]

I'll go look again, but mine felt like I'd break it if I tried to force it down.

Mine didn't want to go on it. And I wasn't sure if it is supposed to sit flat on the bottom.

 

[sniper]

I think it just butts up against it. Mine will not go over that peg without breaking. I measured it with calipers and it's a no-go. If you look closely you can see other little tabs to help position it if it's butted up but not over.

They fit it's just real tight and takes some force to get it on there

are you on air domes and rez? They are looking perfect.

Not yet hoping the Dutch pro nutes show up soon they have had a gallon of grow more sea grow top fed but kinda hoping the Dutch pro shows up before they need another drink cause sea grow leaves a build up and that would be a pain to clean out the lines and valves
And haven't started the airdomes yet either

 

[Archaic]

Is it supposed to sit up off of the bottom? Mine has the little tabs on the side that align with everything and the long tab that aligns under the outer float.

If I want to get the half moon on that cross on mine it's either going to take a dremal or a hammer.

Ignore the lead sinker, I'm training the hose to make the bend. If it doesn't have to sit on the bottom I might be able to force it part way on.

 

[wwwillie]

Hey,
I too thought they would break. I ended with a flooded tent. They go over the post. Really they do.

 

[Frank Nitty]

Is it supposed to sit up off of the bottom? Mine has the little tabs on the side that align with everything and the long tab that aligns under the outer float.

If I want to get the half moon on that cross on mine it's either going to take a dremal or a hammer.

View attachment 955951

Ignore the lead sinker, I'm training the hose to make the bend. If it doesn't have to sit on the bottom I might be able to force it part way on.

View attachment 955952

Yes, off the bottom...

 

[Frank Nitty]

hmmmmmmm maybe they changed the design. I know on mine, the instructions say to set it on the post.

Push until it stops...

 

[Archaic]

Oh, well if its not supposed to touch the bottom I can probably force it part way. I thought the whole point was a tight seal on the bottom.

 

[Dudeski]

I read where it is to keep it from floating. I will give it another try. Glad I'm not the only one!

 

[sniper]

Oh, well if its not supposed to touch the bottom I can probably force it part way. I thought the whole point was a tight seal on the bottom.

No It just goes down to that tab that I was seconds away from removing with a knife then I said self maybe it's not an over pour of plastic let's check the other 3 ok so they all have it so let's just check to see if it works right
Sure enough didn't need to do anything but make sure the tray was level