Live Stoner Chat Live Stoner Chat - Apr-Jun '23

Status
Not open for further replies.
Goodmorning! :smokeout:
6mbar11i1k7b1 (1).jpg
 
Yeah but apparently it didn’t see that look in duder’s face “beef it’s what’s for dinner”:drool:
:rofl::rofl:
Those are some badass cows….they live out here with all the predators, snakes etc. Two years ago we were way back in and a came across a big scatter…..either wolves, coyotes, or mountain lion took down a cow, and every animal in the area must’ve showed up. Bones scattered over an area bigger than a football field….and zero meat left…..just bones and hair everywhere. Kinda makes the hair on the back of your neck stand up….
 
I figured just messing.. At least it’s just a cow when I first scrolled by I thought it was wild boar :yoinks::nono::doh::rofl::rofl::rofl:
We have javelinas here….smaller, they travel in packs sometimes…
1688052241478.jpeg
IMG_0432.jpeg

We see them all the time…both in and out of town. They killed my neighbors dog a few years ago…..gotta be smart out here.
 
My new desktop lighting setup is almost done, just one connector for the control board is needed, and of course I don't have one that is the right size....

Here is the led strips, total 45watts, CreScience enhanced strips and a 730nm strip(w/2 leds)
IMG_20230629_095237.jpg


Here is the power/driver and control unit
Looking front to back inside the unit,
IMG_20230629_095405.jpg

From the rear looking forwards, Including the top cover with fan.
IMG_20230629_095445.jpg
 
@Frankthetank and @N/A-Greengo Thanks alot guys!

This unit could also be used for powering some lights for photography in the manual mode. The extrusion's that I mount the strips to can be attached to light and or microphone stands, I tapped the ends with 1/4" x 20 thread's.
 
Status
Not open for further replies.
Back
Top