Lighting Samsung/ Bridgelux eb strips build

[Fitzy]

Just did this build for a 2x4 8 bridgelux 280mm x 20mm strips in 3500k and 4 samsung h serise 280mm x 20mm single row all running off a hlg-185a-700ma
I used 12 led strips
x12 14in long x 1in square alum tubing
x2 30in long x 1in alum angle
18g solid core wire
1 box of no6 self tapping screws
1x hlg-185a-700ma
1x 3 ft 1in flat alum
8 eb 3500k linear strip
4 samsung 3000k linear stip h serise
Kapton tape
Any ? Lmk

 

[Fitzy]

More pics

 

[Boradan]

Looking good.
Where did you get the strips?

 

[Fitzy]

Will be adding 2 meanwell rs-24-15w @ .600 plus ma forget the change with 2 samsung dual row strips and 4 730mn far red but they have yet to be added will update when digi key and heat sink usa parts get hear i got 2 2in heatsinks @14in long for the double chip strips so we will see the rest are on 1in x 14un alum square tubing running at about 85 to 90 degrees f so im interested in how the heatsinks preform.

 

[Fitzy]

Got the bridgelux at digikey but the samsung got on ebay 4 for 40 bucks best deal by far and they were package the best ive seen so far digi keys shipping pading and wraping were good but rhis was awsome imho i will show pics when i get a second

 

[Boradan]

Is the Aluminium square tubes or Angled extrusions (L-shaped)?

EDIT:
Never mind... I re-read your first post...
The L-shaped extrusions would have been better as you will get heat from the LEDs trapped inside the tubes, allowing it to get fairly warm

 

[Fitzy]

Theyhave about a 1x8in gap between the angle and bar also ive check temps on all suface areas inside and out with 93 an change being hottest temp after20 hours of lights on this setup dropped 15degrees avrage room temp compair to wat i was running in this same area

 

[Fitzy]

Just got the double chip also from digi key last photo is the package i got off ebay would highly recomend them best shipping packaging ive seen nothing moved inside and wad a hard card board tube

 

[Fitzy]

Well they loaded odd first 1 is ebay tube and last1 aswell

 

[Fitzy]

So got 2 rs-24v-15w drivers not sure how im going to add them yet but tomaro i will see