Extraction Rosin Tech Pure Solvent Free Wax

[pop22]

well..I've not had much luck but I'm going to try later as I have several strains to test! :smoking:
Going to make that Weedman press and see if that helps! I need an excuse to buy a wax pen..........lol!

 

[Townbike]

I'd like to say , I've been having some good luck with pressing around 260f give or take a few degrees with a hand clamp .. I press for a bit longer but the returns have been pretty good. Mephisto's frosty genetics def play a roll there

Sent from my HTC One_M8 using Tapatalk

 

[briman]

215-220*F for about 10 seconds and one of these...

 

[Jtsmoker]

I finally got this technique to work! I have tried a few times over the last few months with zero success. Same thing was happening last night until I grabbed a chunky freshly clipped bud of TD. I pressed that thing four or five times and got a nice bit of rosin. I had to sample it, of course and since it kept me awake until AFTER 3:00 am, I moved on to some cured indicas that I have. I got nothing - zero, zip, nada from two different strains. Is that common for any of you? If it happens do you just start adjusting heat and pressure?

One last thing, does anyone know if the rosin can be slightly heated, mixed with vapuer extract (PEG 400) and used for e-pen vape oil?

Thanks in advance!!

If you are not pressing it hard enough that can happen and the bud has to be very frosty for a puddle of oil I've had the same out come as you some bud presses better then others

 

[Townbike]

215-220*F for about 10 seconds and one of these...[emoji106]
View attachment 610334

Is that about as low as you can go for flowers with a hair straightener and clamp?

Sent from my HTC One_M8 using Tapatalk

 

[pop22]

whats hard enough and not break the iron??? lol

 

[pop22]

If I get it to work just once, I'll buy a tshirt press!

whats hard enough and not break the iron??? lol

 

[pop22]

hell, I got 1/2 shed of trim.........lol!

 

[gardenhackle]

Has anyone tried clamping buds between a couple plates of aluminum and firing it up with a heat gun?


Sent from my iPhone using Tapatalk

 

[briman]

Squeeze it til you think it's gonna break!You will be able to tell. My iron is set on 4 and that puts me at 220*+ or - 2-4 degrees. Every iron is different and you can get them at thrift stores on the cheap! A infrered temp gun is priceless!!