Live Stoner Chat Live Stoner Chat - Jan-Mar '23

[N/A-Greengo]

Tell them that there are Canucks here...

What is the best online Canadian Vapourizer Store that you frequent?

 

[Frank the Dank]

Okay growmies, Evolv has exceeded my expectations once again with a generous discount offering to the AFN community. From now until 1/16/23, use coupon code autoflower25, and receive 25% off your purchase! That's $100 off the Cricket! A huge thank you to Evolv for the generous hookup!
​

Badass! I’ll get a review done tomorrow and add the coupon to it

 

[Olderfart]

Whats the best online Canadian Vapourizer Store that you frequent?

I've used two, TorontoVape and Planet of the Vapes. I like POV better, but their selection is smaller. Both had first class service and I would buy from them again. Sadly, the last time I was on the POV site, they didn't handle any concentrate devices, only flower.

 

[Fermented_Fruitz]

Hey @Badfinger I would thinl that 12” should be big enough! If anything and to prevent the wood from sagging u can put some casters on the outer edge of the wooden platform with the bearing in the center! Bearing will allow table to spin and the casters will keep board nice and level and make it easier (i would think) to spin it!

 

[Badfinger]

Hey @Badfinger I would thinl that 12” should be big enough! If anything and to prevent the wood from sagging u can put some casters on the outer edge of the wooden platform with the bearing in the center! Bearing will allow table to spin and the casters will keep board nice and level and make it easier (i would think) to spin it!

I'm leaning towards this 24" for $63. If I went with a 46" platform of 3/4 or 1" wood, the 11" of over hang should hopefully not bind up if I have an uneven load on it. So basically I think all that would be needed is the bearing, a 46" pc of wood and maybe a 24-30" pc of wood to set it on. (Due to carpet under the tent.)

Amazon.com: Dailydanny Aluminum Heavy Duty Lazy Susan Rotating Turntable Bearing Swivel Plate Hardware for Dining-Table (24 inch (16mm)): Home & Kitchen

 

[Badfinger]

I only have front access to my tent, so you all know how much of a pain it can be to water the back plants, especially once their full grown.

 

[Badfinger]

 

[Badfinger]

 

[Mara Cachafa]

I'm leaning towards this 24" for $63. If I went with a 46" platform of 3/4 or 1" wood, the 11" of over hang should hopefully not bind up if I have an uneven load on it. So basically I think all that would be needed is the bearing, a 46" pc of wood and maybe a 24-30" pc of wood to set it on. (Due to carpet under the tent.)

Amazon.com: Dailydanny Aluminum Heavy Duty Lazy Susan Rotating Turntable Bearing Swivel Plate Hardware for Dining-Table (24 inch (16mm)): Home & Kitchen

With 300 lb. capacity it should be plenty strong enough, as long as the plants on opposite sides are similar in weight. But with 4 plants in a 4x4 tent, won't they fill up the square corners of the tent pretty quick, and refuse to budge? My plants have been getting so top heavy I don't dare try to move them for the last month of flower.

 

[mdabber]

I only have front access to my tent, so you all know how much of a pain it can be to water the back plants, especially once their full grown.

You just gotta take them out