Hey guys. Is this light burn ?

[Dank Nuggets]

I use a 50ml shot class for measuring my nutrients out. This what I put in a 10L watering can after week 5 to 6 and 15ml of pk once at week 7. Hope it helps

1. 40ml of A
2. 40ml of B
3. 25ml of ryzotonic
4. 25ml of cannzym
5. 5ml cal mag
6. 40ml of boost
7. 10ml of it garlic

 

[Just done]

when i used the chart i never got past the veg part of it never used there flower bit coz i found it just burnt plants to fck i think the chart is more for photo not autos i think

Ya man. I’m still using like the veg one. First one and on minimums

 

[Just done]

Thanks for all the response boys. Really helpful. I would of used pk more often. Now I know I will use it just once in like week 7 . And now I know I need to stick to minimum in the chart aswell.

 

[Just done]

I use a 50ml shot class for measuring my nutrients out. This what I put in a 10L watering can after week 5 to 6 and 15ml of pk once at week 7. Hope it helps

1. 40ml of A
2. 40ml of B
3. 25ml of ryzotonic
4. 25ml of cannzym
5. 5ml cal mag
6. 40ml of boost
7. 10ml of it garlic

But it’s from week 5-6 like in deep flower ?
now I’m in week 4 and I use on 10 litres water.
10 of calmag . 20 of A 20 of B . 20 of RIZO. Will get cannyz and bost tomorrow . I mix them in order I said. Or should there be any other order ? ( I mean putting them to water )

 

[Dank Nuggets]

But it’s from week 5-6 like in deep flower ?
now I’m in week 4 and I use on 10 litres water.
10 of calmag . 20 of A 20 of B . 20 of RIZO. Will get cannyz and bost tomorrow . I mix them in order I said. Or should there be any other order ? ( I mean putting them to water )

try just 5ml of cal mag and rizo, 25ml of A and B and 25ml of boost and cannzime and see if its ok always feed never plain water ph5.8

 

[Simplicio]

If you can't tell whether it light burn or fertilizer burn, then reduce both.
My autos need less food and light after the stretch, just like in nature.
Fixed problems can take a few days to correct themselves, so give any potential fix time to work.

 

[Mañ'O'Green]

Unless your LEDs can produce over 1200 PPFD there is no way it is light burn. I ran ChilLed lights 1400 PPFD 3 inches from my tops and no light burn. They will burn if they physically touch the diodes. I have also run 60 watt COB LEDs as close as 3 inches with out any light burn!

Light burn happens with HID lamps and this is where the idea comes from.

Supposed light burn 999 times out of 1000 it is a nutrient problem and with most growers it is over feeding. Feeding unbalanced nutrients is the next reason and then under feeding. Under feeding is a rare event here.

 

[Just done]

try just 5ml of cal mag and rizo, 25ml of A and B and 25ml of boost and cannzime and see if its ok always feed never plain water ph5.8

Will do. Thanks brother

 

[Brownthumbs]

@Mañ'O'Green

Hmmmm. i've been running this:

Series 3+ Full Spec 250 Watt Dimmable Grow Light

Our Series 3+ Full Spec 250 Watt Indoor LED grow light is designed to be the ultimate Full Cycle unit to optimize growth in each stage. Each kit utilizes 2 of our custom designed & full spectrum LED boards with Samsung LM301H, UVA, Samsung LH351H Deep Red 660nm / Far Red 730nm, and Cree XPE2...

www.budgetgrowlights.com

Inside of this, full bore at 16".

And i have this. Pretty sure it is light burn. Fading leaves from the top down, tips slightly burnt, leaves curling:

i order this to hopefully get it dialed in.

 

[Just done]

try just 5ml of cal mag and rizo, 25ml of A and B and 25ml of boost and cannzime and see if its ok always feed never plain water ph5.8

Is boost worth it brother ? It Avery expensive