Indoor First Coco Grow - Runtz & Stardawg

Day 34 Runtz.

@St. Tom how much you reckon this big girl gonna yield? I reckon at least 4oz when she finishes.

20210604_111103.jpg
 
Carbon filter and fan finally arrived. So will be getting this setup today and hopefully the environment will be better during the zipdoor is zipped.

Will also be transplanting the 11 day old stardawg into a square 15L fabric pot with coco filled to the brim. I have a small experiment I want to try regarding this.. and haven't used a square fabric pot as of yet.

I will post pictures of my setup and transplant later when I get that done and rearranged to better suit the gals.

My big runtz gal is taking up a lot of space by herself now so some rearranging is required.

Peace :woohoo1:
 
Stardawg has now been transplanted. I should have done it at 14 days I reckon, but didn't want to risk too much root bound.

I think I should've waited until the roots were a tiny bit more established but ill see how she responds tomorrow.

20210604_193311.jpg


20210604_193242.jpg
 
Day 35 runtz.


Slightly defoliated her and lollipopped her. Removed small growth from the lowest parts of the plant.

Fed her 4ml bloom per 2L. 600 ppms.

She is showing signs of preflower now so no doubt she has about a week or less until she develops more pistols.

20210605_153434.jpg
 
Day 38 Runtz

Gonna have to give her a trim again. She is throwing more pistils but insanely bushy. Just branches everywhere and gonna have to open her up a bit to get more light in there.

20210608_121422.jpg
20210608_121411.jpg


Day 15 Stardawg:

She is due another feed today. I fed her some AN bloom with a light dose of calmag and DutchPro TakeRoot and she's established a full new set of leaves over night. Excited to see how she looks in 15 days again.

20210608_121243.jpg

20210608_121246.jpg
 
Some more defoliation on big runtz girl with lollipopping. Hope i haven't screwed her over too much.
20210608_183935.jpg
 
Despite a rough start, looks like its going quite well. You still working on getting your new space setup?
 
Despite a rough start, looks like its going quite well. You still working on getting your new space setup?

I had it all using reflective walls but they are somewhat insulated so they keep it warmer than I like.

I attempted to install my carbon filter and fan... the fan was pretty damn loud which sucks.

The fan also would not connect to filter although they were designed to be 5". I only received one line of ducting and had to attempt to cut a bit off so i could use another part of it to attach to the filter. This way I could get it all fitted properly.

After making the cut, i realised there is no way I am going to cut through the steel cabling inside the ducting so it hasn't been used yet.

I am unable to set it up until I can get a hold of some steel cable cutter next week.

I am also trying to think my fan situation through. I want my fan blowing from above but it does prove challenging because of my limited space. I wwnt it above so i have more space below. I only have one pole inside that is mounted to the walls that my lights hang on.

The runtz girl is starting to take up major space. She is pretty big
 
Back
Top