B
berryrydin2
Guest
The grow space i will be using is from college grow box, it is the HPS hindu kush grow cab. Dimensions HEIGHT 36", LENGTH 25" , WIDTH 19 "
150 CFM EXHAUST FAN along with Can o filter 1500 carbon filter. I am thinking of purchasing another small 150 cfm fan. THOUGHTS?
I have 3 options for my lighting which i am considering, a. a 250w MH hung directly above resevoir along with 2 150w cfls one on each side of the resevoir, b. a 250w HPS on top with the cfls on each side, c. one 200/250W HPS and one 200/250W MH on top with no side lights. I am also willing to run options a and b without the side-CFLs I AM CONCERNED WITH LIGHTING AS SPACE IS AN ISSUE BUT THE TOP OF THE ENCLOSURE CAN BE RAISED IF NEEDED. I do not want to cause heat or light stress with too many lights but also want to produce the healthiest yeilding plants possibly.
It has a 12-15qt resevoir tank which i have decided to use, monitered by a PH, temperature, and ppm reader at all times. I also have an air stone running as well.
water will be between 65-75F @ around 68F preferred temp, PH 5.5-6.5 @ 5.9-6.0 optimum level
I am using 1.5" rockwool cubes with clay pellets for a medium.
Only nutes i will be using are Botanicare CNS 17 Grow, and Botanicare CNS17 Bloom.
from wat i understand grow nutes will only be used during weeks 2,3, and half of 4 and ONLY AT 1/4 STRENGTH DOSE. At four i will switch to the Bloom formula also at 1/4 STRENGTH DOSE for the remaining weeks 5,6,7,8,9. I READ SOMEWHERE THAT FOR AUTOFLOWERING PLANTS IT IS GOOD TO CONTINUE YOUR PLANTS WITH A NITORGEN ADDITIVE IN WEEK 4. BUT NO LONGER THAN THAT. THE REASONING BEHIND THIS WAS BECAUSE OF THEIR SHORT LIFESPAN AND ALMOST NON-EXISTENT VEG STATE, THE PLANT WILL USE THE EXTRA WEEK OF NITROGEN FEEDING TO CONTINUE ITS RAPID GROWTH AND PRODUCTION OF BUDS. Week 9-10 i will begin flushing for a week and week 10-11 will be when i harvest. IS THERE ANYTHING SPECIFIC I NEED FOR FLUSHING OR IS TAP WATER OK?
Both strains i have should be ready to harvest around days 65-75 but as i am only growing 5 at a time Berry ryder should be the focus of attention.
I have found minimal material on nutrient feeding for auto flowers.
ALSO WAT IS THE BEST WAY TO DRAIN AND REPLENISH?
From wat i have read it should have a full drain and replenish after day 14. from then on it should be done once every 7-9 days to give roots an air bathe which they seem to enjoy and benefit from tremendously. FACT OR FICTION?
i have found next to nothing on either strain, no grow journals, except only one somewhat informtaive autofloweirng dwc journal. From his experince with deisle ryder, the less nutes the better.
Ppm was low 110-260s in veg 300-350 in transition to flowering n early flower and gradually to 560 or so a few days before harvest. I know they seem low but it seems auto flowers are very picky with their nutes so i want to start off slowly n gradually increase from there.
if anyone could help me figure out how much my ppm should be around each week throughout the grow that would be awesome.
150 CFM EXHAUST FAN along with Can o filter 1500 carbon filter. I am thinking of purchasing another small 150 cfm fan. THOUGHTS?
I have 3 options for my lighting which i am considering, a. a 250w MH hung directly above resevoir along with 2 150w cfls one on each side of the resevoir, b. a 250w HPS on top with the cfls on each side, c. one 200/250W HPS and one 200/250W MH on top with no side lights. I am also willing to run options a and b without the side-CFLs I AM CONCERNED WITH LIGHTING AS SPACE IS AN ISSUE BUT THE TOP OF THE ENCLOSURE CAN BE RAISED IF NEEDED. I do not want to cause heat or light stress with too many lights but also want to produce the healthiest yeilding plants possibly.
It has a 12-15qt resevoir tank which i have decided to use, monitered by a PH, temperature, and ppm reader at all times. I also have an air stone running as well.
water will be between 65-75F @ around 68F preferred temp, PH 5.5-6.5 @ 5.9-6.0 optimum level
I am using 1.5" rockwool cubes with clay pellets for a medium.
Only nutes i will be using are Botanicare CNS 17 Grow, and Botanicare CNS17 Bloom.
from wat i understand grow nutes will only be used during weeks 2,3, and half of 4 and ONLY AT 1/4 STRENGTH DOSE. At four i will switch to the Bloom formula also at 1/4 STRENGTH DOSE for the remaining weeks 5,6,7,8,9. I READ SOMEWHERE THAT FOR AUTOFLOWERING PLANTS IT IS GOOD TO CONTINUE YOUR PLANTS WITH A NITORGEN ADDITIVE IN WEEK 4. BUT NO LONGER THAN THAT. THE REASONING BEHIND THIS WAS BECAUSE OF THEIR SHORT LIFESPAN AND ALMOST NON-EXISTENT VEG STATE, THE PLANT WILL USE THE EXTRA WEEK OF NITROGEN FEEDING TO CONTINUE ITS RAPID GROWTH AND PRODUCTION OF BUDS. Week 9-10 i will begin flushing for a week and week 10-11 will be when i harvest. IS THERE ANYTHING SPECIFIC I NEED FOR FLUSHING OR IS TAP WATER OK?
Both strains i have should be ready to harvest around days 65-75 but as i am only growing 5 at a time Berry ryder should be the focus of attention.
I have found minimal material on nutrient feeding for auto flowers.
ALSO WAT IS THE BEST WAY TO DRAIN AND REPLENISH?
From wat i have read it should have a full drain and replenish after day 14. from then on it should be done once every 7-9 days to give roots an air bathe which they seem to enjoy and benefit from tremendously. FACT OR FICTION?
i have found next to nothing on either strain, no grow journals, except only one somewhat informtaive autofloweirng dwc journal. From his experince with deisle ryder, the less nutes the better.
Ppm was low 110-260s in veg 300-350 in transition to flowering n early flower and gradually to 560 or so a few days before harvest. I know they seem low but it seems auto flowers are very picky with their nutes so i want to start off slowly n gradually increase from there.
if anyone could help me figure out how much my ppm should be around each week throughout the grow that would be awesome.
