Day 0: Dropping seeds into Rapid Rooters & Autopot Setup
This tray fits perfectly at the bottom of my grow tent.
Adding 2 autopots to my tent. Turned them on once to check if they work and then drained trays.
Medium setup went like this:
1. 1.5 inch of Clay Pebbles at the bottom of pot (I've been told they cause pH drift but I bought them already so I might as well try)
2. Fill up Coco Coir / Perlite combination. (70/30 mix from Hydro Crunch)
3. Put Rapid Rooter in the middle.
4. Added 4L to each of the 2 pots and let them drain. 3mL/gal Cal-Mag & .5tsp/gal of Recharge (Found this combo from reddit user r/Oreck420)
5. Wait until they drain out and then put them into the autopot trays.
Drop the seed in and cover up the top a lil by a pinch with the rapid rooter.
Give a final small watering over the rapid rooter and I moistened the propagation lids by spraying them before putting them on the pots.
Final Notes of Day 0:
Planted at 3PM on Nov 19, 2020.
Tap Water: 7.8 pH & 112 ppm.
After the recipe: 6.1 pH & 215 ppm (ppm went down from 300 because I put too much pH down and I had to dilute it...)
The pH runoff when I was buffering the medium was 6.0.
This tray fits perfectly at the bottom of my grow tent.
Adding 2 autopots to my tent. Turned them on once to check if they work and then drained trays.
Medium setup went like this:
1. 1.5 inch of Clay Pebbles at the bottom of pot (I've been told they cause pH drift but I bought them already so I might as well try)
2. Fill up Coco Coir / Perlite combination. (70/30 mix from Hydro Crunch)
3. Put Rapid Rooter in the middle.
4. Added 4L to each of the 2 pots and let them drain. 3mL/gal Cal-Mag & .5tsp/gal of Recharge (Found this combo from reddit user r/Oreck420)
5. Wait until they drain out and then put them into the autopot trays.
Drop the seed in and cover up the top a lil by a pinch with the rapid rooter.
Give a final small watering over the rapid rooter and I moistened the propagation lids by spraying them before putting them on the pots.
Final Notes of Day 0:
Planted at 3PM on Nov 19, 2020.
Tap Water: 7.8 pH & 112 ppm.
After the recipe: 6.1 pH & 215 ppm (ppm went down from 300 because I put too much pH down and I had to dilute it...)
The pH runoff when I was buffering the medium was 6.0.
Last edited: