Im venting in to my house , it’s high humidity in the house aswell so Intake air is high humidity. I was thinking more about these. Like hang 5-10 in tent .How many plants do you have, what is your ventilation like, and what growth stage are you in? Are you venting outside / to the attic, or just to the lung room (i.e., the room that the tent is in)? What are the temps and humidity in the lung room like?
Overall, desiccant-type dehumidifiers like those may be too low capacity for the amount of water you need to remove.
Here's some typical (per plant) water consumption rates:
View attachment 1358096
For example, here's one that sounds like what you're thinking of, but it only has a total capacity of 4-6 oz before needing to be recharged. Meanwhile, 450 mL = 15 oz. Most of your actual moisture removal usually comes from ventilation, so I'd recommend modifying that first based on your setup. If you do try dehumidifiers like those, I'd make sure to put them in the path of your intake air flow.
Im venting in to my house , it’s high humidity in the house aswell so Intake air is high humidity. I was thinking more about these. Like hang 5-10 in tent .
Best bet is to just go buy a normal adjustable dehumidifier and get the whole house humidity down 1st or even just the room the tent is in
I had a Co² monitor when I was running Co². 6 plants in a 4x6x8 would use Co² from ambient ~410 PPM down to less than 100 PPM in 3 hours. They will stop growing at 150 PPM.@Mañ'O'Green See this thread for a discussion of CO2 needs. Only a small percentage of water is used for photosynthesis with the rest being used for just transpiration, so the CO2 needs are a lot smaller than you'd expect. Each plant should only need on the order of ~1 cfm of fresh air for CO2 purposes, which shouldn't be an issue for any typical home setup.