colloidal silver 8ppm

[evol]

I have used the same silver wires for over 10 batches of cs and they are fine.,they will last a long time if you keep them clean after use.

 

[EverythingsHazy]

If the silver is actually .9999% pure, they should last until they are worn away. Enough to reverse more plants than you'll likely need to in years.

 

[natertots]

I just happen to have 1g bars where can I get that wire at when I run out? Awesome help too guys, thanks alot. It was at 19ppm 2 hours ago and it just looks like water. There is 1 little black ball at the bottom though.

 

[evol]

jewelry stores, eBay, probably Amazon..

black stuff at the bottom is just corrosion. if you have a laser pointer you can shine it through the water every couple of hours and you will notice the beam gets thicker/more visable

 

[natertots]

Still says 19 :/ cleaned connections again. I think it would be going quicker if I cleaned it more often. Sounds easy enough till you throw a 1 year old in the mix lol.

 

[evol]

How far apart are the bars from eachother?

 

[natertots]

Bout 0.75-1in. It was at 22 ppm before I went to bed so I already started spraying plant c)

 

[thetreeman]

My cs takes about 2 days to brew. I can get it up to about 20ppm and it is pretty yellow at that point. It also really hurts the leaves after several applications at that strength. I would suggest using a lower PPM and applying more frequently if possible. 12 to 15ppm should be fine if you apply it at the right time in the plants development. Once the plant is actively flowering, its much harder to reverse in my experience. Currently I have a plant that I started spraying earlier and its got lots of ballz, took about 2 weeks to turn it tho.

 

[evol]

You can stop it at 22ppm. Should work well

 

[bromhexine]

think year old mix will still work? also i found powdered cs 200mg packets think that'll do? anyone know how i'd mix that in the right dose?