Indoor A.I. Growroom Build (Aquarium Interface)

[BayLee420]

is contained in having enough outside air venting in

There maybe a misunderstanding here. I don't mean actual "Outside" air. Fresh air from the room the closet is in is what I mean.

My Armoire exhaust goes right into the Den. I have one window fan bringing fresh air into the room and the opposite window fan exhausts the Den's air. In the Summer I have an a/c in the "Intake" window to keep the Den's temp in control. It's always a test every day to keep the Den's room temp in check. Sometimes it's more intake, sometimes it's more room air exhaust.

Right now my grow needs more warmth because they are in the seedling stage. I don't even have the window fans on now. This keeps the grow space nice and warm. As the girls get bigger I'll bring more cooler air into the Den to keep the inside grow temp between 75F-82F.

 

[Betelnut]

Ahh, I see what you mean.

Do you need to worry much about co2 in small spaces like these if the air is being exchanged with a larger, although somewhat closed, room?

Sent from my SCL22 using Tapatalk

 

[BayLee420]

There should be enough co2 in our environment to more than be adequate for our girls.

Adding Co2 is something I know very little about.

@Rhyce Saroni had a Co2 generator in the original Rhyceland. He's abandoned that on the New Rhyceland. Wasn't worth it.


Sent from my iPhone using Tapatalk

 

[Betelnut]

Hi Folks,
I got the movie screen I'm using as a reflector and light block for the doors put up. I also got the in-line-fan, ducting, carbon filter, etc. ordered.

Here is the closet now:

There is still a lot of light leaking, but it is a start.

The next thing is to get this Aquarium Controller mounted:

And then install the intake fan into the bottom left of the left-hand door.
By then hopefully the exhaust setup will be here and I can finally get some air movin'!

 

[Betelnut]

So I am getting a late start, but I finally got my new inline and filter. So today I am going to get down to cutting up my walls/doors!

I hope to at least get the input fan installed on the door and the exhaust mounted. I may need to run to the hardware store before I can install the exhaust port though.
I decided to limit* my smoking until after I at least get that much done!

Here is the room now, I hope my next update in a few hours or so will be looking a lot better!

* By "limit" I just mean, you know, "limit". Lets not get crazy here...

 

[Betelnut]

Baby steps…

 

[Betelnut]

Step two lol.

 

[BayLee420]

Keep It Simple...looking good.

 

[Betelnut]

I had a gig so I had to take a break, but now it is time to finish up.

This was the point of no return lol.

Last sawing for the day.

 

[Betelnut]

I finished installing the fans and ducts, so air is flowing!

Next is the electrical stuff, and maybe a bit more sound dampening.


Sent from my SCL22 using Tapatalk