New Grower 1st Indoor Grow-Hillbilly Rigged Setup

There’s a new addition to the hillbilly crew! Purple Bastard Eater
View attachment 1286445
At least the humidity is dialed in:yoinks:
View attachment 1286446
You-can-do-it.gif
 
Hey! Another one up already! What about wrapping the area with the pot with some of that mylar bubble wrap insulation? Try to direct more of that limited light at the plant. I think you can get a roll pretty cheap at the depot or lowes.
 
Hey! Another one up already! What about wrapping the area with the pot with some of that mylar bubble wrap insulation? Try to direct more of that limited light at the plant. I think you can get a roll pretty cheap at the depot or lowes.
I’m going to have to think about implementing that. Thanks!
 
:yoinks: damn growmie, lookz like u got a wee bit more than we did, lol :rofl: i'd say we've got 7-8" on the ground atm...and it'z warmin up, woot! :yay: ppp
 
We got about 12 inches on top of a layer of ice, but luckily the power only went out for a few minutes. :pass:
 
Poor little Bastard is yellowing around the edges. 1 week old and is growing normally. Any ideas on what can cause this? In Biobizz light, spraying with water several times a day, watered about 1/3 bottle of water from bottom 2 days ago and a bit around the stem this morning. Temps 75-84 F

Possible culprits?
-Extreme low humidity 16-24%
-Under watering
-A bit too much silica in the bottom watering

The Bastard is getting sun today in front of a window. Window is in a small area and I have a humidifier blasting to get it in some air with a bit more moisture. Not too worried at this point, will monitor for signs of progression with the issue.

Anyone have knowledge on what typically causes this?
0B6938C0-A500-4A8C-B418-4E1CAA2F89DD.jpeg
 
Back
Top