Indoor MasonJar’s Indoor Adventure

[MasonJarOG]

Midnight Marathon fans

Whole shabang

Harvey Wallbanger

Midnight Marathon

Buildasoil is a wealth of info.

 

[MasonJarOG]

Midnight Marathon

 

[MasonJarOG]

Going into week 7
Top dressed today and doing some drybacks

 

[MasonJarOG]

Approaching week 8, did a dry back to 117mb on the blumat sensor and opened the valve on the tank. Recharged the co2 tank with more baking soda and citric acid. 600gr each and 900ml of cold water. Takes about an hour to really build up significant pressure in the tank.

 

[MasonJarOG]

Starting to look like they’ll be done around 75+ days

 

[MasonJarOG]

Heading into week 11 and phased harvest is in progress. Wallbanger was first and all dry now.
Midnight Marathon 1 came down and in the dryer and took the tops from MM 2 while MM3 is still fattening and fading. Been busy and AFN errors out on my uploaded pics due to the size. But got that fixed now I think.
MM2

MM1 greener pheno

Harvey Wallbanger

Herbsnow dryer setup

 

[KingRatt]

Heading into week 11 and phased harvest is in progress. Wallbanger was first and all dry now.
Midnight Marathon 1 came down and in the dryer and took the tops from MM 2 while MM3 is still fattening and fading. Been busy and AFN errors out on my uploaded pics due to the size. But got that fixed now I think.
MM2
View attachment 1730013
View attachment 1730014View attachment 1730015View attachment 1730016View attachment 1730017

MM1 greener pheno
View attachment 1730018View attachment 1730019

Harvey Wallbanger
View attachment 1730020View attachment 1730021
Herbsnow dryer setupView attachment 1730022

How do you like those dryers? How long do they take to dry and all that?

 

[MasonJarOG]

How do you like those dryers? How long do they take to dry and all that?

I love the dryers and use them for everything including mushrooms.
I purchased the extra racks which makes a difference in handling more plant matter. Fill them as full as possible because you get the normal shrinkage. I’ve had smaller lighter flower finish in 30-40hrs and thicker denser stuff go longer than the 96hr default. You don’t get the same look on the looser flower as you would hanging them but I did figure out a way to hang colas in the dryer too if you really want that look but the better dry. They def do not loose anything regarding potency and on rare occasions some plants need a little cure afterwards. 98% of the time it’s primo right from the dryer. The thing you have to get used to is the dry point. Typically when the smaller stems snap clean your on point. Some people like their bud more sticky and soft but to do it properly it’s snap! These big colas I clipped them with the black binder clips by the stems through the tray and took out all the center inserts to stack the outer rings. Otherwise I cut the buds off the stem and rack that sucker full and alternate the layers ring with screen the two blank rings and another layer depending on how fat and big the tops are. I will also just lay longer buds across the trays like my other photos. All a matter of preference and what works. I first purchased 1 tried it then picked up two more. It’s great for phasing your harvest and if you like me when you have time.i like to hit the tops first and let the lower half finish longer. I hope this makes sense

 

[MasonJarOG]

Tops off Mm 3 real fatties

 

[Entombed]

Sick lookin buds man. Well fucking done! I'd rep more of your posts if it'd let me right now.