- Joined
- Aug 28, 2018
- Messages
- 1,191
- Reputation
- 0
- Reaction score
- 3,177
- Points
- 0
- Website
- www.autoflower.net
- Currently Smoking
- Forum Stomper, Skywalker, Jack Herer
I found this new germination technique from an Amazon reviewer gardener was using to germinate succulent seeds. I figured why not try cannabis. I modified it a little bit instead of regular towels or napkins. I used this dish washing sponge towel material. Inside a petri dish it keeps humidity and still lets air flow through some. I set it on my T5 ballast stays warm. Got a crystal dwarf sprout just broke soil today. Temps are under control now after my russian fuel sprout died. It was my fault not controlling my temps.
View attachment 975522 View attachment 975523 View attachment 975525
Nice thread!
And that sounds like a good germ method. I created one of my own in thought about a double boiler to melt down chocolate. I stole my wife's Hydroflask and grabbed an empty pill bottle I have used to soak seeds before. Filled the HF with 100F or so water from the tap, let it sit for a few minutes to get the stainless liner inside real warm. Dump it out and replace it to the top with 85F tap water (used a dig. baby therm) and put the cap on it. Then, I put the seeds into a half inch deep PH'ed water with a drop of Kelp Help into the pill bottle, put the cap on it. The reason the water level is low in the pill bottle is to ensure it floats. Then I poured off a tiny bit of water from the HF until the pill bottle lid sat just high enough out of the HF (1/8" or so) to easily grab it and pull it out to check. Then I capped the HF and set it in my bucket of water I always keep bubbling and at 78F with a fish tank heater. I'm not sure if placing it in the bucket of water mattered, because the first time I checked them at 6 hours they were all cracked and ready to go into soil. They were in the pitch black and at a very steady warm temp. Autoseeds Hijack BTW.