hello mate - that stuff is rock hard. The only tip I have for you sit the pipes in hot water for a few seconds before you work on them. It is the standard irrigation fitting - it is a pain but once it is in it stays put nicely.
What you could do also so you dont have to connect/disconnect anything for any purpose is to have it like this: Pump, pipe, drippers, inline tap, pipe, end stop. This way you can always leave the pump there but use teh tap to either feed the drippers by closing the tap, or open it up to the stopper where you can add a hose or something to drain and clean up etc..does that make any sense at all?
looking good mate. The DEADITE will stay small but will be first to Finnish. the rest have monster potential .Flood and drain plants back to hand watering until new tap arrives sadly.. I've had to take the wee Hellraiser out.. there's just no room for her..
Front row L to R.. white chem bronson predator.. theres a wee deadite behind white chem.. and the white cheese is turning into a real stunner up close..
View attachment 1523847View attachment 1523848View attachment 1523850View attachment 1523851View attachment 1523852
And it's plain sailing from here harumph!
Thanks for that m8. So it sits a bit high at one end.. a slight tilt? Cuz that would actually be handy.Hope you might be able to see that tray in my 80x80. Like I said it fits but not square. Little off the corners will be easy.
View attachment 1525319
View attachment 1525320