Colloidal Silver, The first batch...

[ottawaauto]

Hello everyone, I've taken a interest in creating seeds. I started 3 months ago with 10 ww/autos from CropKing. I sprayed 2 of them completely once a day from day 21 or so with some internet colloidal silver. nothing happened. I harvested a pound of great smoke and 4 oz of coconut oil but 0 seeds.

I'm trying to make my own colloidal silver this time as I believe the stuff i got was just bad.

So i went o the store, the store, you know, amazon.. and bought 99.9% silver 6 inch 14ga wires. I got a power adapter 800ma and set it on 7.5v. Set the wires in a mason jar approx 1.5 inch apart and let it go 10 hours. I cleaned the rods off between naps, I love naps. I cleaned them 2x, once after 4 hours and again after 7 hours. both wires were crusty, 1 black colored. MIx is a cloudy sort of light brown.. laser pointer now shows up when pointed through the glass. but my PPM, wait.. i better tldr this..

TLDR - Question: my colloidal silver soloution doesnt read as anything when i use my bluelab ppm meter, it reads 0, is this normal?

 

[Aunty Edna]

Mine read 0.01 and produced lots of pollen. If it shows up under the lazer you are good to go.
Let the bad stuff settle in the bottom of the jar and skim off the clean stuff.

 

[ottawaauto]

Ty Aunty Edna, I suspected that was the case. I've 4 little green crack photos, I'll try it on 1. (although I don't really want any photo seeds) Perhaps they can be crossed auto somewhere down the line.
Ive bought a new camera a few months ago, I will document the change and post the results in a month (fingers crossed).

Whats your process of skimming the solution?

 

[Aunty Edna]

Ty Aunty Edna, I suspected that was the case. I've 4 little green crack photos, I'll try it on 1. (although I don't really want any photo seeds) Perhaps they can be crossed auto somewhere down the line.
Ive bought a new camera a few months ago, I will document the change and post the results in a month (fingers crossed).

Whats your process of skimming the solution?

Shake the jar up and let the heavier pieces settle, then just pour the water out leaving the last bit of dirty water in the jar.
Only spray a single side branch, doing a full plant gets out of hand fast, especially if you are only playing around.

 

[ottawaauto]

Aunty Edna, thx for that. I have 2x 10oz glass bottle sprayers that i put electricians tape all over the outside. they will receive the solution.

Im not sure what you mean by getting out of hand, do you mean the pollen may contaminate the main grow?

This project is conducted in a separate building far away from the main grow. I have 2x 450w viprasectras for the project. today i will start spaying 1 entire plant, and in 2 weeks seperate it from the others and go 12/12. 2 weeks after that (spraying entire plant 1x each day) i will move it back and switch all 4 to 12/12.

thats the plan anyways

 

[ottawaauto]

im going to try to upload the picks as they are today no spray yet

 

[ottawaauto]

user error,hold on

 

[Aunty Edna]

I mean it becomes a lot of spraying and you need a LOT of CS. You will simply produce too much pollen.

 

[Aunty Edna]

This is a few bananas worth of pollen. Spraying an entire plant creates thousands of bananas. You only need a few...