DIY Making a DIY cloner. Need feedback on which material to use.

Joined
Dec 23, 2011
Messages
342
Reputation
0
Reaction score
9
Points
0
Website
www.swecan.se
Hey, i am in need of some feedback on my project. I am going to make a simple bubbler/cloner, and i´m stuck. I need to figure out what material that´s ok to use when i´m going to get to the part where the cuttings are set in, and that holds the stalks.
I think that they usually are some sort of rubber that´s cut like Pacman.

I hope you guys can understand what i´m talking about. If not. ask me, and i will try to be a little bit clearer.

Peace guys! :)
 
cc.jpg you want something like this

http://www.atlantishydroponics.com/VIAGROW-Viagrow-Neoprene-Clone-Machine-Lids-175-x-75-6635
 
Hey, i am in need of some feedback on my project. I am going to make a simple bubbler/cloner, and i´m stuck. I need to figure out what material that´s ok to use when i´m going to get to the part where the cuttings are set in, and that holds the stalks.
I think that they usually are some sort of rubber that´s cut like Pacman.

I hope you guys can understand what i´m talking about. If not. ask me, and i will try to be a little bit clearer.

Peace guys! :)

You had me at Pacman.
:peace:
 
Not one uping me just threw an idea out threre . you can get it cheaper at w-mart/dollor stores



:peace:
 
Good morning. :) I was looking for a cheap material that i may have home. I have checked with my grow shop and they don´t have those plugs. :(
 
Back
Top