Indoor Grow No.2 - Hippy, Mephisto, Cobs and Good Vibes :)

[Hippy_BiotabsF70]

Nice one. I see you've copied my floor boards too lol.

Mate when I saw your photos I actually suspected we live in the same road hahahaha! Same boards, same rads, same thermos lol. Weird.

 

[wayward1]

Well I've got tent envy. Bit like penis envy only a lot more serious cos mines only a 2X2, shoved at the back of a built in cupboard in the bedroom with nowhere to extract the stale air. but at least I've got light.

 

[wayward1]

Hats off to you. That is one seriously good first grow you've got there. That bud your holding looks absolutely perfect

 

[Hippy_BiotabsF70]

That made me laugh because it's true! At my age my tent is more important than my todger lols

 

[Hippy_BiotabsF70]

Hats off to you. That is one seriously good first grow you've got there. That bud your holding looks absolutely perfect

Thanks mate I really appreciate your kind words

However its amazing what a camera does - they're definitely not perfect! Hoping that by sacrificing one head a day off my amnesia twins I can be patient enough to let the fast buds girls fatten out as much as possible.

 

[wayward1]

Now your just being stupid. You must of smoked that bud in one go! Lol

 

[Hippy_BiotabsF70]

Today's sacrificial offering from the "not ready yet but I will cut the others down if I don't smoke it" amnesia [emoji106]

Sent from my iPhone using Tapatalk

 

[Hippy_BiotabsF70]

Now your just being stupid. You must of smoked that bud in one go! Lol

Trust me bro that's not ALL I'm schmokin

 

[Hippy_BiotabsF70]

@wayward1 I meant to ask you mate what's the deal with your grounding arrangement on your frame? Is that's special fixing of some sort? Does it need grounding?

Thanks mate [emoji3]


Sent from my iPhone using Tapatalk

 

[wayward1]

It's what you use to ground your copper pipes below kitchen sink or near your gas boiler. You can always wind your ground wire round a bolt and squash it to between the frame and a washer. I intend to move mine to one of the supporting beams when I fit the junction box as it makes more of a contact with the frames. Technically the 4 short ends won't be properly protected cos they are insulated with the plastic corners. Only minimal contact is made to them via the heat sinks. Hope this makes sense.