thanks bro! They doing super today, I got in there and did some LST... Maybe later today I will do a little light pruning on 1 or 2 of them....all not ready for pruning just yet..
Thanks budthe grey-ish tips I guess or white-ish I didn't rinse the coco well enough, so that was my fault... I Thought I had soaked with 6.0, flushed with 6.0 and pre-charged at 5.98, but I must not of ran enough though, this was first time using this brand of coco.. So I think it's a bit higher then other's I used just from run off I checked.. No biggy, them well under control now... I just never remove leave until the growth doing fine and 100% stable, if ya take off before plant stable it will just move on to other leaves.. That I can safely remove, but I'm just waiting for more green to fill in first I not want to slow the growth down at all just to take off the ugly leaves, they'll be off soon enough.
oh they are fine, I'm in sealed tent. so kinda easy to maintain temps/humidity .. Because of test light I am using, my temps little lower then where I would prefer them using co2 supplement... I have right about 80degree's, but with co2 burner I been trying maintain 85degree's, I been flooding every 40-45mins..4-6mins floods...My humidity I have between 65%-71% that too I would like higher like 80% but my temps would need be at 91-92 and I just can't get them up that high with a single lamp & co2 burner..Theyre coming on well now dude
Hows ypur temps and humidity through winter?
I think once I finish the test on this light and I run it in with my 2-600w Meizhi Led's , I'll be able maintain the temps I want and I'd be willing to bet even better growth then I'm seeing now. I actually find it harder to review light by it self, I wouldn't ever be using it this way, if not for the test and them wanting test done without supplemental lighting, although I'd see results much better if I was able to use supplemental lighting for several reasons, for one this light doesn't cover my entire foot-print...I really love the light and all that, but honestly in a real world setting I think results be easier to see... It really wouldn't be hard to notice a difference between the hps/mh and LEC if I was using as hybrid like I was using the hps/mh... it will really be hard to tell using this way, because I am using like 1/3 amount of power and my entire footprint isn't completely covered...unable get desired temps with single lamp.....After I complete the required test/reviews on this, I do intend to run a couple reviews using it in Hybrid setup...I am 100% certain I will get very favorable results that way......I will be able have temps where they should be, my environment will be much-much more dialed in... Right now is the best I can do with a single light...I just can't get my environment where it needs to be with a single lamp, it just doesn't get warm enough...If I had the 630w version of this light then I probably wouldn't need supplemental lighting..and that would probably also help keep temps where I need them with co2 supplement, My temps kinda low for co2 supplement..
The outside temps suck, we got hammered with a Blizzard yesterday that dumped 30inches of snow on us.. Another maybe coming Monday....Theyre coming on well now dude
Hows ypur temps and humidity through winter?
It seems, I got my feed well dialed in now... Using co2 is like using NoS /Super-charger injection on a race car, you need higher octane fuel and the tune just right. Same with co2. it's been really-really difficult for me to get this dialed in using much lower temps & humidity then I am used too... I pretty much encountered every issue possible since start of this grow, ph issue's calmag issue's, more calmag issue's temp & humidity issues... Using a Test light during test grow is a little tricky, I honestly had no idea where to start off with calmag, I went with 1.5ml to start at pre-charge but quickly realized that wasn't nearly enough, then to 2.0ml still not enough to 2.5ml was getting close, but still needed go up, so under this light all of these plants been wanting 2.7-.2.8ml calimag, that seemed to help clear up the stems as well...Still the temps/humidity are much lower then I would like using CO2 supplement, My environment just is not in optimal range..I really am doing the best with temps I got, it's really throwing things off a bit for me though... Now my co2 bags are really producing, I really not need to run co2 burner ...so more or less I been running like 2-3mins instead not really for the co2, but for the heat.. it will only go up maybe 1.5degree's in that time, so I been kinda stuck at 80 degree's...ughhh that really is too low for co2, like 10degree's to low and because temps are too low,so is humidity them need to be brought up at same time. This about one of the most challenging grows I had to deal with when comes to temps/humidity and all that, I will really be quite happy after reviews are done on this LEC, so I can run it in a Hybrid setup and maintain the Optimal Conditions...I think my reviews on this light will be so much better when I can use it in an optimal environment, a single 315w lamp just doesn't get warm enough for someone using co2, without co2 this has to be like perfect for them not in a sealed tent like myself. I'm still very happy how they responding to this light, they are doing quite well but i have had issue after issue trying get this dialed in with lower temps/humidity & co2....I think as temps start to rise outside in coming weeks, maybe It will help bring temps up slightly.. i doubt it will do much as the temps outside tent always remain around 64-65 anyways.. Anyways, I just letting ya guys know kinda the issues to date... I think we pretty dialed in with these lower temps, The feed seems correct now..The always look like they praying to the light, The inter-node distance is very impressive to me...I focus on that a lot, the plants are very well branched, I finally got most or all of the ugly off them now....The C.C I think is going to be very wide, that seems to be the way she taken shape.. Each plant I done something a little different in way I pruned to see what results I like the most and which produces the nicest looking plant..I bet in maybe a 3x3 tent this light would be perfect since that is the coverage area as well, I think in that size higher temps can be maintained little better..So it has nothing to do with the light, the light is GREAT really, it's just a little under-sized for my grow area is all.Hello Guys/Gals , Today is another update..Today they are at Day 28 and doing Great! I am still maintaining perfect inter-node spacing, The plants are doing great They not super tall but are getting really bushy with really nice structures on each,So far they really are looking pretty awesome, not quite as big as I figured they would be by this time...But I do think maybe by the next update, there will be huge changes. The C.C will end up having a nice flat canopy, that one is coming out really beautiful, The C.A also doing great that won't be as bushy as the C.C but still expect both to look very nice. Enjoy!
View attachment 875702 View attachment 875703 View attachment 875704 View attachment 875705 View attachment 875706 View attachment 875707 View attachment 875708 View attachment 875709 View attachment 875710 View attachment 875711 View attachment 875712 View attachment 875713 View attachment 875714
