Live Stoner Chat Fancy New Toy

[KCinKC]

Today Amazon decided to deliver my Cloudline T4... I wasn't planning to get any kind of ventilation but I'm liking it so far...
The wife wants me to put a filter on it so the neighbors don't complain...
Does anyone have a recommendation...?
I don't want to go all out, just something that works... So far I'm lucky enough I have not had to use any type of clamps to hold things together which gives a cleaner look (I like my room to look nice)...

Also, I have the probe hanging about 12" from the ceiling in the center of the grow area...
Is that the best place...? I "could" read the instructions but all else has not failed yet...

 

[AutoWonders]

Today Amazon decided to deliver my Cloudline T4... I wasn't planning to get any kind of ventilation but I'm liking it so far...
The wife wants me to put a filter on it so the neighbors don't complain...
Does anyone have a recommendation...?
I don't want to go all out, just something that works... So far I'm lucky enough I have not had to use any type of clamps to hold things together which gives a cleaner look (I like my room to look nice)...

Also, I have the probe hanging about 12" from the ceiling in the center of the grow area...
Is that the best place...? I "could" read the instructions but all else has not failed yet... View attachment 1164164View attachment 1164165View attachment 1164166View attachment 1164167

I've pretty much used Phresh filters from the get go. For a lot of years, however, they are a higher priced filter.

I use two remote probes (so I can monitor downstairs) at top of canopy and one near middle top the ceiling.

 

[automan2]

I place the probe of my inkbird in the charcoal canister prefilter, then calibrate to match my canopy temps. Setting a low deviation keeps my tent regulated very well.
The only problem with automation is it's taking away all the "messing with stuff" we old potheads are used to doing!

 

[Mizzo81]

Phresh. I have a phat filter that’s held up through a few grows too. Phresh I had to order the phat is what the local store had. Both seem to work can have full tent of flowering plants and small tent hang drying with no odors in the house.

 

[Death The Cultivator]

I've been using an IPower 6in carbon filter for a few years

 

[Olderfart]

My 6" vivosun worked perfectly for my grow. I vented internally within the basement, and there was never any odour in the house. Since this was only one grow, I can't comment on longevity, but the filter worked perfectly for over 90 days, and appears to be very well made.

 

[KCinKC]

Probably a mistake but I went with the matching filter...
I did come up with a super easy way to put everything together...
I screwed picture hanging things to the filter and hung with a simple hook I bent...
They're spaced just right so it can't move or fall and only takes seconds to remove/install...
I still need to caulk outside, make a little screen for the fresh air vent and tomorrow I can remove
the ugly mess holding my duct steady...

No hose clamps or anything permanently attached except the seal around the duct through the foam insulation...
Everything else is "press to fit" and very solid...
I did use a strip of black duct tape on the fan/filter connection but even it really wasn't needed...

A quick FYI if you are sealing things up on the outside...
Caulk the GREEN arrows DO NOT CAULK RED ARROWS...
This allows any moisture that might collect to drain out the bottom edge...

Yes, it is hanging down about 1/4" on the right but I'm sure my OCD will take care of that... A small shim on the fan mount will line things right up...
Don't worry, I put the sock on too...

 

[Kyote]

Today Amazon decided to deliver my Cloudline T4... I wasn't planning to get any kind of ventilation but I'm liking it so far...
The wife wants me to put a filter on it so the neighbors don't complain...
Does anyone have a recommendation...?
I don't want to go all out, just something that works... So far I'm lucky enough I have not had to use any type of clamps to hold things together which gives a cleaner look (I like my room to look nice)...

Also, I have the probe hanging about 12" from the ceiling in the center of the grow area...
Is that the best place...? I "could" read the instructions but all else has not failed yet...
QUOTE]

Oh ya i got a bit envious of all the space you have, even room for a chair. Sweet it is

 

[KCinKC]

Here you go Kyote...
The view from my chair...lol...
I mostly use it as a step / bench but I do sit and look at the girls too...

 

[Kyote]

Here you go Kyote...
The view from my chair...lol...
I mostly use it as a step / bench but I do sit and look at the girls too... View attachment 1164831

Ya right? I had a great outdoor spot when I lived in the Okanagan Valley. Flowers, bushes, birds, all around my patch with a chair, and a 10 x 10 insulated cabin for drying. Moved to Vancouver Island last year to a small place so I only have a 3 x 3 with no room for a chair. Thanks for sharing!