Lighting Bunny's Telos Tales

@Grim Reefer Good to hear from you old friend. The new GN tech is great! A little powerful early on but not a problem if you have head room. Spectrum and penetration are bang on. What projects do you have cooking?
Sweet, I can't wait to see more from you dude .
Oh I won't be growing again for some time. But I'll be back around to keep an eye on all of you once again
 
4883BA60-4F62-48F5-B847-9102B88114EE.jpeg
AE1CE9FC-A352-4A1D-B69E-EC85618BB05D.jpeg
30612639-AB23-49B7-97FB-1F8A742958F2.jpeg
AD0A5D65-0ABD-48FD-94A8-586F4D209B05.jpeg
 

Attachments

  • DBFDD9E3-4578-46C4-96F0-0C67475B3A9B.jpeg
    DBFDD9E3-4578-46C4-96F0-0C67475B3A9B.jpeg
    101.2 KB · Views: 60
Last edited:
image.jpg


Dabbing in the propogation shed @archie gemmill I rewired my Dabstaion to accept 710 coils. So worth it . Got some Durban Poison and Think Fast photos germinating and so,e Auto Lemon zkittles for good measure. All for outside
 
@archie gemmill yes she has back off! The new Axil coil Wraps all the way round it's an 150w coil, It's Amazing using Your favourite bangers and caps. There beveled opaque bangers are the best for the money i have seen as well. Check out the 710 coils website. The rewire just involes unscrewing three wires and moving them and re screwing then cutting one finally the hard part soldering one cable to a spare pin. Not too bad my enail was sitting dormant. Even if I was using it this is so much better.
 
EF1D9897-04B4-44BB-B2CE-572A315ECB49.jpeg



@archie gemmill sorry for the slow reply had a date with some Sour Diesel Diamonds! Funny the above image is one you posted.

To rewire the Dabstation our config is top 710 bottom . undo the cables on the controller end at the screw terminals. As seen below Move the yellow thermocouple cables and connect the thermocouple + to power + and then thermocouple - to power -.If You look in the picture you have two cables left coming from where the coil connects no.4 black connects to thermocouple - on the controller and 5 red is cut and terminated I used a wago any connector will do. Using the cut cable connect it to thermocouple + on the controller with the cables connector and solder to pin 3 which you can see is free. Sounds harder than it is. Once you open it. It will make sense. Laters

D2DC862A-7BAF-4534-8BC7-08E6E725A03B.jpeg
 
Last edited:
ahh cheers :thumbsup: i meant to order a couple of whips from china in the hope that one was the right way round.but ya know the stonner in me never got round to it :baked:
:pighug:
 
Back
Top