Lighting Building light from pre existing drivers

[brian247]

Hey how are you guys, so basically I was able to snag what I believe to be galaxy hydro led for very cheap and I want to use these drivers to build a new light with. So there are two drivers and the specs are Pri: 100-240V AC 50-60Hz Sec: DC 60-80V 690mA+/-5%. There are also two fans but they are run on an independant driver as well (so technically three drivers). What could I run on this and would it be worth it?

 

[BigSm0]

You would be best with 2 citizen 1212's, 36v X 690ma would give you just under 25 Watts per cob. You would only use the driver going to the Leds. 50 watts for 30 dollars is a deal.

 

[brian247]

Ok so as far as I can see both drivers are going to the leds because both drivers have a labeled input and output, so would that allow me to pull 100w with 4 leds? I am pretty sure this light draws around 130-140w from wall.

 

[wwwillie]

Hey!
Looks like @BigSm0 hss everything under control. He’ll take great care of you.
Peace and happy growing.

 

[brian247]

For sure thank you and one more thing, I have an old post that I am looking to remove but couldn't and some things in life have changed since then so I went ahead and started this thread.

 

[wwwillie]

For sure thank you and one more thing, I have an old post that I am looking to remove but couldn't and some things in life have changed since then so I went ahead and started this thread.

No worries!
What was that thread you wanted removed, we'll get it done.

 

[brian247]

It is called "Building my 1st light" , I wanted to build this light up before I take the next step to set up the bigger grow room haha (this light is for a small legal grow at my place) so I will talk with you guys when I get to building the larger lights as well haha.