Indoor Auto Spanish Diesel Test Grow Dope-Seeds ShortStuff
- Thread starter Grey Bear
- Start date
S
SUPERWEED
Guest
GREAT START on a great projekt !!!
good thread and good information to :dig:
I must say it is impressive to grow as you do
one day I myself dare me to it! but feels that so much can go wrong !!! but hope all goes well for you
GOODLUCK GREY BEAR !!
good thread and good information to :dig:
I must say it is impressive to grow as you do
one day I myself dare me to it! but feels that so much can go wrong !!! but hope all goes well for you GOODLUCK GREY BEAR !!
Grey Bear
Confidential Cultivator
Auto Spanish Diesel Day 64
34" tall-
36" around, she was spreading her shit everywhere, I finally ahd to just tie her and Bud Cannon up to keep them a bit more manageable
You will notice a bit of light burn and heat stress. Raised the light, nothing to be done for the heat.
Growth is good. nice little bushy plant.
She is finally starting to put out some pistils.
I am guessing we are going to be going past 80 days with her, but we will see.
Canopy is very even, (t5 growers would like this one.)
Branches are thick, ends seem to be toughening up. I am still adding AN Rhino for silica.
Feed is
CalMag+ @ 3ml per 4l A must have as I grow under LEDs
Hygrozyme @ 2.5 ml per liter (Hygrozyme is my enzyme product of choice) If you don't use a chiller, you should use a quality enzyme product.
Then add
AN ph perfect Connoisseur to EC 1.5
Then additives Bud Factor X, Bud Candy, Bud Ignitor & Rhino
EC will run a bit wild and settle to 1.8 ish
Light-270w LED GB Prototype
Additional 4 bulb 2' HOT5 GB Prototype is directed from the side and slightly above plant as well
I run my lights 24/0
Ambient temps run around 79-86
rez temps 60-76 It has been smoking hot here lately and rez temps have been on the high side, but she does not seem to mind other than showing some ragged fan leaves. Nothing bad though.
Thanks for looking,
GB
34" tall-
36" around, she was spreading her shit everywhere, I finally ahd to just tie her and Bud Cannon up to keep them a bit more manageable
You will notice a bit of light burn and heat stress. Raised the light, nothing to be done for the heat.
Growth is good. nice little bushy plant.
She is finally starting to put out some pistils.
I am guessing we are going to be going past 80 days with her, but we will see.
Canopy is very even, (t5 growers would like this one.)
Branches are thick, ends seem to be toughening up. I am still adding AN Rhino for silica.
Feed is
CalMag+ @ 3ml per 4l A must have as I grow under LEDs
Hygrozyme @ 2.5 ml per liter (Hygrozyme is my enzyme product of choice) If you don't use a chiller, you should use a quality enzyme product.
Then add
AN ph perfect Connoisseur to EC 1.5
Then additives Bud Factor X, Bud Candy, Bud Ignitor & Rhino
EC will run a bit wild and settle to 1.8 ish
Light-270w LED GB Prototype
Additional 4 bulb 2' HOT5 GB Prototype is directed from the side and slightly above plant as well
I run my lights 24/0
Ambient temps run around 79-86
rez temps 60-76 It has been smoking hot here lately and rez temps have been on the high side, but she does not seem to mind other than showing some ragged fan leaves. Nothing bad though.
Thanks for looking,
GB
Attachments
Blowing it up GB!! Fat girls you have going on!! How many gallons are you running in your cooler rez? Spot on Brother!
:kusht:
:kusht:
Grey Bear
Confidential Cultivator
Auto Spanish Diesel Day 68
34" tall-
36" around, she was spreading her shit everywhere, I finally had to just tie her and turn her whole rez and Bud Cannon got a bit shoved around to keep them a bit more manageable
You will notice a bit of light burn and heat stress. Raised the light, nothing to be done or the leaves that got scorched
Growth is good. nice little bushy plant.
She is starting to load on the pistils
I am guessing we are going to be going past 80 days with her
Canopy is very even, (t5 growers would like this one.)
Branches are thick, ends seem to be toughening up. I am still adding AN Rhino for silica.
Feed is
CalMag+ @ 3ml per 4l A must have as I grow under LEDs
Hygrozyme @ 2.5 ml per liter (Hygrozyme is my enzyme product of choice) If you don't use a chiller, you should use a quality enzyme product.
Then add
AN ph perfect Connoisseur to EC 1.5
Then additives Bud Factor X, Bud Candy, Bud Ignitor & Rhino
EC will run a bit wild and settle to 1.8 ish
Light-270w LED GB Prototype
Additional 4 bulb 2' HOT5 GB Prototype is directed from the side and slightly above plant as well
I run my lights 24/0
Ambient temps run around 79-86
rez temps 60-76
Thanks for looking,
GB
34" tall-
36" around, she was spreading her shit everywhere, I finally had to just tie her and turn her whole rez and Bud Cannon got a bit shoved around to keep them a bit more manageable
You will notice a bit of light burn and heat stress. Raised the light, nothing to be done or the leaves that got scorched
Growth is good. nice little bushy plant.
She is starting to load on the pistils
I am guessing we are going to be going past 80 days with her
Canopy is very even, (t5 growers would like this one.)
Branches are thick, ends seem to be toughening up. I am still adding AN Rhino for silica.
Feed is
CalMag+ @ 3ml per 4l A must have as I grow under LEDs
Hygrozyme @ 2.5 ml per liter (Hygrozyme is my enzyme product of choice) If you don't use a chiller, you should use a quality enzyme product.
Then add
AN ph perfect Connoisseur to EC 1.5
Then additives Bud Factor X, Bud Candy, Bud Ignitor & Rhino
EC will run a bit wild and settle to 1.8 ish
Light-270w LED GB Prototype
Additional 4 bulb 2' HOT5 GB Prototype is directed from the side and slightly above plant as well
I run my lights 24/0
Ambient temps run around 79-86
rez temps 60-76
Thanks for looking,
GB
Attachments
Grey Bear
Confidential Cultivator
Auto Spanish Diesel Day 80
sorry about the missed updates. family stuff
I can't imagine that I will even begin flush before day 90-95.
I wish that I had been anticipating her spread, she could have easily had a 48"x 48" footprint, If I would have had the room.
34" tall-
36" around, she was spreading her shit everywhere, I finally had to just tie her and turn her whole rez and Bud Cannon got a bit shoved around to keep them a bit more manageable
You will notice a bit of light burn and heat stress. Raised the light, nothing to be done or the leaves that got scorched.
As previously mentioned, getting these lights figured out, so some light burn still obvious.
Growth is good. nice little bushy plant.
She is starting to load on the bud.
I am guessing we are going to be going past 80 days with her
Canopy is very even, (t5 growers would like this one.)
Branches are thick, ends seem to be toughening up. I am still adding AN Rhino for silica.
Feed is
CalMag+ @ 3ml per 4l A must have as I grow under LEDs
Hygrozyme @ 2.5 ml per liter (Hygrozyme is my enzyme product of choice) If you don't use a chiller, you should use a quality enzyme product.
Then add
AN ph perfect Connoisseur to EC 1.5
Then additives Bud Factor X, Bud Candy, Bud Ignitor & Rhino
EC will run a bit wild and settle to 1.8 ish
Light-270w LED GB Prototype
Additional 4 bulb 2' HOT5 GB Prototype is directed from the side and slightly above plant as well
I run my lights 24/0
Ambient temps run around 75-84
rez temps 60-73
Thanks for looking,
GB
sorry about the missed updates. family stuff
I can't imagine that I will even begin flush before day 90-95.
I wish that I had been anticipating her spread, she could have easily had a 48"x 48" footprint, If I would have had the room.
34" tall-
36" around, she was spreading her shit everywhere, I finally had to just tie her and turn her whole rez and Bud Cannon got a bit shoved around to keep them a bit more manageable
You will notice a bit of light burn and heat stress. Raised the light, nothing to be done or the leaves that got scorched.
As previously mentioned, getting these lights figured out, so some light burn still obvious.
Growth is good. nice little bushy plant.
She is starting to load on the bud.
I am guessing we are going to be going past 80 days with her
Canopy is very even, (t5 growers would like this one.)
Branches are thick, ends seem to be toughening up. I am still adding AN Rhino for silica.
Feed is
CalMag+ @ 3ml per 4l A must have as I grow under LEDs
Hygrozyme @ 2.5 ml per liter (Hygrozyme is my enzyme product of choice) If you don't use a chiller, you should use a quality enzyme product.
Then add
AN ph perfect Connoisseur to EC 1.5
Then additives Bud Factor X, Bud Candy, Bud Ignitor & Rhino
EC will run a bit wild and settle to 1.8 ish
Light-270w LED GB Prototype
Additional 4 bulb 2' HOT5 GB Prototype is directed from the side and slightly above plant as well
I run my lights 24/0
Ambient temps run around 75-84
rez temps 60-73
Thanks for looking,
GB
Attachments
Grey Bear
Confidential Cultivator
PS.
The stink has arrived.
ralph!
between the obnoxious rotten fruit smell the Tha Shiznit is delivering
and the "dogshit diesel" smell this ASD just kicked out, my grow room is not exactly a whiff of delight.
must get much bigger carbon filter whenever the next little windfall comes my way.
The stink has arrived.
ralph!
between the obnoxious rotten fruit smell the Tha Shiznit is delivering
and the "dogshit diesel" smell this ASD just kicked out, my grow room is not exactly a whiff of delight.
must get much bigger carbon filter whenever the next little windfall comes my way.
Grey Bear
Confidential Cultivator
Auto Spanish Diesel Day 97
Yikes I didn't realize it had been over two weeks since last post.
I have started the flush and given her the "pre chop trim"
34" tall-
36" around,
She caught me off guard as to her foot print.
I think I this one can produce more, if you know how much space you need up front.
Also this girl had to be tied, ends are very floppy and cannot take a bunch of manhandling.
You will notice a bit of light burn and heat stress. Raised the light, nothing to be done or the leaves that got scorched.
As previously mentioned, getting these lights figured out, so some light burn still obvious.
Feed is
CalMag+ @ 3ml per 4l A must have as I grow under LEDs
Hygrozyme @ 2.5 ml per liter (Hygrozyme is my enzyme product of choice) If you don't use a chiller, you should use a quality enzyme product.
Then add
AN ph perfect Connoisseur to EC 1.5
Then additives Bud Factor X, Bud Candy, Overdrive & Rhino
EC will run a bit wild and settle to 1.6 ish
Light-270w LED GB Prototype
Additional 4 bulb 2' HOT5 GB Prototype is directed from the side and slightly above plant as well
I run my lights 24/0
Ambient temps run around 75-84
rez temps 60-73
Thanks for looking,
GB
Yikes I didn't realize it had been over two weeks since last post.
I have started the flush and given her the "pre chop trim"
34" tall-
36" around,
She caught me off guard as to her foot print.
I think I this one can produce more, if you know how much space you need up front.
Also this girl had to be tied, ends are very floppy and cannot take a bunch of manhandling.
You will notice a bit of light burn and heat stress. Raised the light, nothing to be done or the leaves that got scorched.
As previously mentioned, getting these lights figured out, so some light burn still obvious.
Feed is
CalMag+ @ 3ml per 4l A must have as I grow under LEDs
Hygrozyme @ 2.5 ml per liter (Hygrozyme is my enzyme product of choice) If you don't use a chiller, you should use a quality enzyme product.
Then add
AN ph perfect Connoisseur to EC 1.5
Then additives Bud Factor X, Bud Candy, Overdrive & Rhino
EC will run a bit wild and settle to 1.6 ish
Light-270w LED GB Prototype
Additional 4 bulb 2' HOT5 GB Prototype is directed from the side and slightly above plant as well
I run my lights 24/0
Ambient temps run around 75-84
rez temps 60-73
Thanks for looking,
GB
Attachments
Similar threads
