Something wrong?Edited out for the vibe...good luck on your grows guys
Sub'd up man.
I am using 1 gram of MC per liter. Twice as much as yours. How did you decide how much to use? This is a table I put together based on @slowandeasy testing with greenleaf products. I have done parts of a run in bloom phase using this schedule and its good. And just starting a new run and using the veg part of the schedule with no issues or nute burn.
View attachment 901152
Thanks for the chart - good info.
I fail to see how your math works though.
This is the plants' first week (the feed amount is for day 1, when they went into the reservoir.)
According to your chart, I should be using 2.0g per gallon (is this a US gallon or an imperial gallon???)
If it's a US gallon, then 1 gallon = 3.785411784 litres.
2/3.785411784 = 0.5283441047162968g per Litre.
I used 0.4535714285714286g per litre.
That's only about 12% less than you have in your chart.
I am using Tap Water for the base with 200(ish) ppm, and am sitting at about 330ppm. Any higher may not be a good idea for seedlings.
Actually, my own math was wrong too - well, the math was good, but the starting figure was incorrect.I must have done the math wrong when I read your feeding data. I was going to say that the plants look great anyway and that's what matters!
Make sure to keep close eye on pH. Also, 2g of MC is not much. I would be prepared to up the strength, especially using Cobs. Watch for Calmag def or pale growth. Good luckDay 9 Update:
Smooth going until yesterday morning when my (cheap) pH pen decided to give up the ghost.
I have ordered a Bluelab Growers Toolbox and will be using pH strips temporarily until the new pH pen arrives.
The Taproot is now nicely reaching out of the netpot and into the reservoir.
Will be watching like a hawkMake sure to keep close eye on pH. Also, 2g of MC is not much. I would be prepared to up the strength, especially using Cobs. Watch for Calmag def or pale growth. Good luck