Status
Not open for further replies.



6_n.jpg
 
Heya brotha.... what kind of rez? how much water? it's usually less wasteful to remove half or less of the water, maybe a third. And add plain pH'd water first and drop the PPM that way.
Rez is an AeroGarden - stripped of everything besides the re-circulation pump. One gallon capacity.

If it's just a nute issue, the flush should take care of it. Not so much worried about wasting a gallon of nutes, far cheaper than stomping all over the yield, anyway. It sure looked like some teeny bugs were chomping away, but I don't see that pattern on the lower leaves, which I would expect it.

To compound matters, I managed to break the sensor on my pH meter last night. Replacement will be here tomorrow evening, so I'll have to use the old chemical test to at least get it close to 6.0.

Thanks for replying, bro! If this thing pulls through, i'll smoke one up in your honor! Hell, make that two!
 
Rez is an AeroGarden - stripped of everything besides the re-circulation pump. One gallon capacity.

If it's just a nute issue, the flush should take care of it. Not so much worried about wasting a gallon of nutes, far cheaper than stomping all over the yield, anyway. It sure looked like some teeny bugs were chomping away, but I don't see that pattern on the lower leaves, which I would expect it.

To compound matters, I managed to break the sensor on my pH meter last night. Replacement will be here tomorrow evening, so I'll have to use the old chemical test to at least get it close to 6.0.

Thanks for replying, bro! If this thing pulls through, i'll smoke one up in your honor! Hell, make that two!


Damn dude, that happened to me a few months ago. busted a pH meter during a rez change. She pulled through though. You're gonna lose some leaf, and set her back a bit. With just a gallon, no worries, change it out. I might consider leaving her in plain water till you get your meter.
 
Status
Not open for further replies.
Back
Top